This section describes how to configure L3 routed uplinks with a static route.
Home > Networking Solutions > Storage Networking > Guides > Dell EMC SmartFabric Services with PowerEdge Servers, PowerStore Storage Appliance, and Isilon Storage > Static route example
This section describes how to configure L3 routed uplinks with a static route.
The following table shows the values entered in the SFS UI to configure the L3 uplinks for this example.
Field name | Leaf1A-to-External-A | Leaf1A-to-External-B | Leaf1B-to-External-A | Leaf1B-to-External-B |
Uplink Port Type | L3 | L3 | L3 | L3 |
L3 Type | L3 Routed Interface | L3 Routed Interface | L3 Routed Interface | L3 Routed Interface |
Uplink Name | Leaf1A-to-External-A | Leaf1A-to-External-B | Leaf1B-to-External-A | Leaf1B-to-External-B |
Switch Group | Leaf | Leaf | Leaf | Leaf |
Rack | Rack 1 | Rack 1 | Rack 1 | Rack 1 |
Node | Leaf1A | Leaf1A | Leaf1B | Leaf1B |
Interface | Ethernet 1/1/55:1 | Ethernet 1/1/56:1 | Ethernet 1/1/55:1 | Ethernet 1/1/56:1 |
Network Name | Leaf1A-to-ExtA | Leaf1A-to-ExtB | Leaf1B-to-ExtA | Leaf1B-to-ExtB |
Prefix Length | 31 | 31 | 31 | 31 |
IP Address | 192.168.1.1 | 192.168.2.1 | 192.168.1.3 | 192.168.2.3 |
Routing Protocol | eBGP | eBGP | eBGP | eBGP |
Policy Name | eBGP-Leaf1A-to-ExtA | eBGP-Leaf1A-to-ExtB | eBGP-Leaf1B-to-ExtA | eBGP-Leaf1B-to-ExtB |
Peer Interface IP Address | 192.168.1.0 | 192.168.2.0 | 192.168.1.2 | 192.168.2.2 |
Peer ASN | 65101 | 65101 | 65101 | 65101 |
BFD Neighbor | Disable | Disable | Disable | Disable |
Fabric Interconnect | unchecked | unchecked | unchecked | unchecked |
For each uplink, run the following procedure to configure L3 routed uplinks with a static route using the values from the preceding table.
The SFS UI Topology page appears, as shown in the following figure.