Ensure that the physical VLTi connections are made between leaf pairs before proceeding.
To place the leaf switches in SmartFabric mode, configure them as VLT peers and run the following commands on each switch:
OS10# configure terminal
OS10(config)# smartfabric l3fabric enable role LEAF vlti ethernet 1/1/49-1/1/52
Reboot to change the personality? [yes/no]:y
The configuration is applied, and the switches reload.
To verify that the switches are in SmartFabric mode, run the following command on each switch:
OS10# show switch-operating-mode
Switch-Operating-Mode : Smart Fabric Mode