The following sections describe the optional advanced configurations that are supported and listed within the Activation Quick Start Guide that is included with the SD-WAN Edge 640 system.
Set up a static IP address
- Connect the SD-WAN Edge 640system through Ethernet or Wi-Fi and obtain a DHCP IP address.Note: In this example, GE1 is used.
- Open a web browser and type http://192.168.2.1 in the address bar.
- Click the Details button located below the image of the SD-WAN Edge 640.
- In the Edge Overview section of the screen, click the Connected button to view the connected interfaces.
- Click the name of the interface you want to set with a static IP address.Note: In this example, the WAN interface is connected to GE3, shown in red.
- Under Configuration > Addressing, select the Static radio button, then type the IP Address, Subnet Mask, and Gateways in the appropriate text boxes.
- Click Save (upper-right of the Configuration screen) to apply the settings.
- When prompted, type the default username admin and the default password admin and click OK. The SD-WAN Edge 640 attempts to reach the SD-WAN Gateway address, and the icon will turn green when successful.Note: Based on your service provider, a VLAN ID may be required.
Set up PPPoE
To configure PPPoE, perform the following steps:
- Connect through Ethernet or Wi-Fi and obtain a DHCP IP address from the SD-WAN Edge 640.Note: In this example, GE1 is used.
- Open a web browser and type http://192.168.2.1 in the address bar.
- Click the Details button located below the image of the SD-WAN Edge 640.
- Click the name of the interface you want to configure for PPPoE, for example, GE3.
- Under Configuration > Addressing, select the Static radio button, and enter the Username and Password.
- Click Save (upper-right of the Configuration screen) to apply the settings.
- When prompted, type in the default username admin and the default password admin and click OK.
Install and configure an SFP module as WAN interface
- Verify that the SFP module you want to install is compatible with the device.Note: For information about compatibility, contact your Dell Technologies Sales Representative.
- Insert the SFP module in either SFP1 or SFP2.Note: If the link lights do not illuminate, use the UI to reboot the SD-WAN Edge 640 system.
- When the module is ready, it shows as Available in the WAN interface with the associated DHCP address.