Your Browser is Out of Date

Nytro.ai uses technology that works best in other browsers.
For a full experience use one of the browsers below
Azure Portal Deployment and Operations Guide with Switchless Networking
About using this guide Revision history Deployment Introduction Solution introduction Solution Deployment
Solution Deployment
Solution deployment introduction
Deployment prerequisites
Change operating system to iDRAC pass-through IPs Install Windows Admin Center Install OpenManage Integration with Microsoft Windows Admin Center
Predeployment configuration
Configuring network switches Configuring iDRAC and BIOS Configure Intel E810 NICs
Cabling instructions
Two-node, back-to-back connected architecture Three-node, single-link full mesh switchless interconnect Three-node, dual-link full mesh switchless interconnect
Operating system deployment
Manual operating system deployment Factory-installed operating system deployment Configure host networking
Install roles and features
Configuration to prepare nodes
Change the hostname
Registry settings
Verifying and updating firmware and software compliance
Assess environment readiness
Configuring firewall settings
Deploy a cluster with Azure Stack HCI 23H2 operating system Update Azure Stack HCI clusters using SBE package GPU Integration Registering a Partner Admin Link (PAL) for Azure related solutions Dell OpenManage Integration with Windows Admin Center Updates and maintenance Secure connect gateway References

Change the hostname

Home > Integrated Products > Microsoft HCI Solutions from Dell Technologies > Guides 23H2 and later > Azure Portal Deployment and Operations Guide with Switchless Networking > Change the hostname

Change the hostname

  • By default, the operating system deployment assigns a random name as the host system name. For easier identification and uniform configuration, Dell Technologies recommends that you change the hostname to something that is relevant and easily identifiable.

    Change the hostname by using the Rename-Computer cmdlet:

    Rename-Computer -NewName Node01 -Restart

    Note: This command induces an automatic restart at the end of rename operation.