Steps to create the MTree replication:
- From the AWS management Console, Edit the Production DDVE Security Group
- Create an outbound rule on TCP port 2051, using the following parameters:
- The IP version is IPv4.
- The type is Custom TCP.
- The protocol is TCP.
- The port range is 2051.
- The destination is the IP used for replication on the CR DDVE system.
- Create an outbound rule on TCP port 3009, using the following parameters:
- The IP version is IPv4.
- The type is Custom TCP.
- The protocol is TCP.
- The port range is 3009.
- The destination is the IP used for replication on the CR DDVE system.
- From the AWS management Console, Edit the CR DDVE Security Group
- Create an inbound rule on TCP port 2051, using the following parameters:
- The type is HTTPS.
- The protocol is TCP.
- The port range is 2051.
- The source is Custom.
- The value of the source is the Production DDVE Instance IP.
- Create an inbound rule on TCP port 3009, using the following parameters:
- The type is HTTPS.
- The protocol is TCP.
- The port range is 3009.
- The source is Custom.
- The value of the source is the Production DDVE Instance IP.
- From the AWS management Console, Edit the PPCR Mgmt Host and DDVE Subnet Network ACL.
- Create an inbound rule on TCP port 2051, using the following parameters:
- A rule number, which you provide.
- The type is Custom.
- The protocol is TCP.
- The port range is 2051.
- The source is the Production DDVE Instance IP.
- The value for Allow/Deny is Allow.
- Create an inbound rule on TCP port 3009, using the following parameters:
- A rule number, which you provide.
- The type is Custom.
- The protocol is TCP.
- The port range is 3009.
- The source is the Production DDVE Instance IP.
- The value for Allow/Deny is Allow.
- Log in to the production DDVE with the username sysadmin.
- Select Data Management.
- Select MTree.
- Locate the MTree where the backups are written and make a note of the MTree Name. This MTree name will be use in the Source Path field in a future step.
- Click Replication.
- Click Create Pair.
- Verify that the Replication Direction is set to Outbound.
- Verify that the Replication Type is set to MTree.
- Under Replication Details, the Source System should contain the FQDN for the production DDVE.
- In the Source Path field, enter the MTree name that is entered in Step 7.
- Next to Destination System click Add System.
- The Add System window opens.
- In the System field, enter the FQDN for the Vault DDVE in the Dell PowerProtect Cyber Recovery vault and Custom Port as 3009.
- In the username field, enter the username sysadmin.
- In the Password field, enter the password for the user sysadmin.
- In the Use Custom Port field, enter port as 3009.
- Click OK.
- In the Destination Path field, enter the same data that was entered in the Source Path field. The destination path is automatically created by the system.
- Click OK to create the replication pair.
- After completing the creation of the replication pair, delete the rules that were created in steps 1,2 and 3.