Use default MPIO settings with the following parameters enabled:
- PathVerifyEnabled - Enable for optimal results with path discovery.
- With “Path Verify Enabled” checked, the target V3 paths will be automatically discovered following an NDM create and a “cancel -revert”
- If “Path Verify Enabled” is cleared, the target V3 paths will not be automatically discovered following an NDM create (host rescan discovers target V3 paths) and a “cancel -revert” may fail. Recommendation is to initiate a manual rescan during the “Wait for host path discovery on Source” step.
- PathVerificationPeriod - Set a time in seconds for automatic path detections. Dell Technologies recommends setting it to lowest allowed value between 10 and 30 seconds.