bmo get ipscan -n <sitelocation>
Display the IP scan settings for a site and list the IP addresses for any devices on the network that were discovered during the last scan.
Argument Definition
- sitelocation
- The location that was defined for the site. This CLI command uses the location as the site namespace. For more information about the site location, see Site field definitions.
Example output
The following is an example output for bmo get ipscan -n <sitelocation>
, where the IP scan settings are empty and there are no auto-discovered IP addresses to display.
ip_list: []
last_conf: []
The following is an example output for a populated list of auto-discovered IP addresses from the last time the ipscan
was run, and the current IP scan settings.
ip_list:
100.10.1.2
100.10.1.9
100.10.1.101
100.10.1.102
last_conf
start_range: 100.10.1.0
end_range: 100.10.1.4
subnet_cidr: 100.10.1.8/31
hosts:
- 100.10.1.101
- 100.10.1.102
scan_frequency: 14400 ##entered in seconds
bmo get <device>
, where <device>
is the type of device, such as server
or switch
.