Home > Networking Solutions > Converged and Hyperconverged Solutions > VxRail Networking Solutions > Guides > Dell EMC Networking SmartFabric Services Deployment with VxRail 4.7 > Connect to the SmartFabric GUI
Note: After reloading a switch in SmartFabric mode, it takes about two minutes after the login prompt displays at the switch CLI for SFS to come up and for the GUI to be fully functional. If you connect to a switch in the fabric that is not the master, a link to the master is provided in the GUI. The IPv4 address of the master may also be determined by running show smartfabric cluster from the CLI of any switch in the SmartFabric.
Once logged into the master, the SFS GUI Home page shows the leaf-spine topology and configured uplinks. For the example used in this guide, it appears as shown in Figure 66.
Figure 66. SFS GUI Home page
Note: Since hostnames have not been configured on the four additional switches, each appears with its default hostname, OS10. Hostnames for the additional switches are configured in the next section.