Follow these steps to rescan an onboarded server. You can only scan a single server at a time.
You can rescan a server for various reasons, including: - The previous scan failed.
- The wrong blueprint was selected in the earlier scan.
- Firmware was upgraded.
- No previous scans were run during device discovery.
- From the left-side menu, click Inventory.
The Inventory page is displayed.
- Select a device from the list.
- From the Actions menu, select Rescan Server.
The Scan Device window is displayed.
- Select a Blueprint, Scan type (only Pre-Scan is supported), and Action (Allow or Deny). See Drift detection for information on these settings.
- Click Save to run the rescan.