The QLogic FastLinQ 41262 network adapter supports both iWARP and RoCE.
When used with the QLogic network adapters, the AX nodes are validated only with iWARP. Manually configure the adapter to enable iWARP based on the chosen network configuration.
- During system startup, press F2 to enter system setup and select Device Settings.
- Select the QLogic network adapter from the list of adapters.
- Click Device Level Configuration and ensure that Virtualization Mode is set to None.
- Click Back, and then click NIC Configuration.
- On the NIC Configuration page, select the following options:
- Link Speed: SmartAN
- NIC + RDMA Mode: Enabled
- RDMA Operational Mode: iWARP
- Boot Protocol: None
- Virtual LAN Mode: Disabled
- Click Back, and then click Data Center Bridging (DCB) Settings.
- On the Data Center Bridging (DCB) Settings page, set DCBX Protocol to Disabled.
- Click Back, click Finish, and then click Yes to save the settings.
- Click Yes to return to the Device Settings page.
- Select the second port of the QLogic adapter and repeat the preceding steps.
- Click Finish to return to the System Setup page.
- Click Finish to reboot the system.